SSiittee IInnssttaallllaattiioonn GGuuiiddee This Guide applies to both the Signature Series and Series 500 WeatherHawk System Fa
- 7 - Procedure 1c: Flat Roof Installations 1. For each of the tripod feet, remove the protective paper from one side of the sealing pad t
- 8 - Procedure 1d: Peaked Roof Installations The WeatherHawk wind sensors should be at least 8 feet (2.5 m) above the roof peak, which re
- 9 - Procedure 2: TP1-GK Guy-Wire Kit Installation 1. Cut the guy-wire cable into three equal length pieces. 2. Loop one end of each guy
- 10 - Procedure 3a: Mounting a Series 500 Station on a Tripod or Pole This procedure assumes the WeatherHawk has been setup and tested at
- 11 - Procedure 3b: Mounting a Signature Series Station on a Tripod or Pole This procedure assumes the WeatherHawk has been setup and test
- 12 - 4. Firmly tighten the U-bolt nuts. 5. If the TP1-GK Guy-wire Kit has been installed, assure that its orientation will not interfer
- 13 - Procedure 4: Solar Panel Installation 1. Place the solar panel on the mast below the station to the maximum distance allowed by the
- 14 - Procedure 5: TP1-GR Ground Kit Installation a. Proper earth grounding of the system may be required for both personal safety and rel
- 15 - Appendix A: WeatherHawk Equipment The following equipment is available from WeatherHawk and these items can be ordered on-line at http
- 16 - Power Supplies SP1-KT 1.6 W Solar Panel Kit This solar panel is for use with the WeatherHawk 232 only and when it is located below Lati
- 17 - Mounting/Installation Kits TP1—Tripod/Mast Assembly The TP1 tripod/mast assembly provides a stable support for the WeatherHawk and is
- 18 - TP1-MX—Tripod Mast Extension The TP1-MX extension fits into a ¼” diameter post and is used to increase the height of the WeatherHawk wi
- 19 - HM1—Low Profile Mast Assembly The HM1/low profile mast assembly is a modified satellite dish mast. It provides a stable support for the
- 20 - Customer Service Additional information is provided in “Frequently Asked Questions” on our Web site (www.weatherhawk.com) or you can co
- 21 -
Table of Contents Power Sources ...
- 1 - Site Installation Guide This guide includes procedures for installing your WeatherHawk station on a tripod or pole, on the ground or a
- 2 - An option when obstructions exist is to raise the weather station height above the obstruction by using mast extensions or mounting the
- 3 - Wireless Communications Transmission Ranges Site your WeatherHawk within the spread spectrum radio transmission range. Typical line-of
- 4 - Figure 3: The TP1 Tripod Kit includes the nut and bolt (left) used to attach each foot to the tripod. Testing Radio Transmissions To t
- 5 - 2. If using mast extension(s), drive the extension(s) into the mast by inserting the tapered end of the extension into the top of the
- 6 - Procedure 1b: Ground Installations 1. If needed, prepare the site. A temporary site may require brush or tall weeds to be removed
Commentaires sur ces manuels